Envoy NT9010A Installationsanleitung PDF herunterladen (Seite 9)

Section 1.2: Installing The NT9010

Please read this section to get an overall understanding of the steps involved in

installing the NT9010 system. Carefully work through each step. This will help to

reduce problems and to reduce the overall installation time required.

1.2.1 Out of the

Box

Check the contents label on the outside of the package to ensure all components

have been received.

1.2.2 Create an

Installation

Plan

Draw a rough sketch of the building. Find good locations for the NT9010 control

unit and all the detectors. Here are some guidelines for choosing good mounting

locations.

Choosing a NT9010 Mounting Location

Before you mount the NT9010, you should find a place that is:

• Dry

• Far from sources of interference, including:

■ electrical noise such as computers, televisions and electric motors in appli-

ances and heating and air conditioning units.

■ large metal objects like heating ducts and plumbing which may shield the

antenna.

Choosing Mounting Locations for Wireless Devices

Each type of wireless device has its own set of guidelines for mounting locations.

Before deciding on mounting locations, make sure that you review the guidelines in

the Installation Instructions that come with each device.

1.2.3 Prepare the

Mounting

Location

Once you have selected a suitable place for the NT9010 control unit, make sure

that you will be able to connect the AC power and the telephone line to the

NT9010. If necessary, have an electrician route AC wiring to the mounting location,

and have a telephone installer route the incoming telephone line to the mounting

location.

1.2.4 Installing the

NT9010

Mounting the NT9010 Backplate

The NT9010 backplate is the blue-grey piece of plastic that comes attached to the

back of the NT9010 control unit. This is the mounting plate for the NT9010 unit. It

also provides terminals for connecting the wiring to the NT9010.

NOTE:Complete all wiring before applying AC power.

Figure 1: Removing NT9010 Wall-Mount Backplate

1. Remove

plastic screw

2. Twist with

Screwdriver

2. Twist with

Screwdriver

3. Pull top of backplate

away from NT9010

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Envoy NT9010A Installationsanleitung Seite 9

Kommentare zu diesen Handbüchern